Paper Application Methods

The insulating paper is wrapped firmly, closely, evenly and continuously round the wire.

Construction, unless otherwise specified, is typically one of the following alternatives:

  1. All papers are wrapped in the same direction with the inner paper applied with a butt lap. Successive papers are applied with an advance of 30-50% over the underlying paper with a maximum gap of (.79mm).
  2. Papers are applied with butt intercalation in the following manners:
    1. 2 papers – double butt intercalation – advance 40-60%
    2. 3 papers – triple butt intercalation – advance 28-38%
  3. Papers are lapped in the following manners:
    1. One paper applied with 47-49% overlap – equivalent to two papers.
    2. One paper applied with 64-66% overlap – equivalent to three papers.
    3. Two papers each applied in the one of the above manners.

The taping angle (measured between the paper and longitudinal axis of the wire) is normally in the range of 45-60 degrees, however, certain unusual sizes and constructions may necessitate angles outside this range.

Insulated Wire Dimensions

When build is specified only by number of papers there is no requirement for finished dimensions, however constructions of types (a) and (b) contain the specified number of papers, and type (c) shall contain the equivalent number of specified papers.

When build is specified the tolerances of the paper additions to conductor thickness and width shall be as specified in table P1.

Flexibility

Conductors under (6.35mm) thickness shall withstand 180 degrees flatwise bending around a mandrel 6 times the conductor thickness in both directions without exposure of the conductor.

Conductors (6.35mm) and over in thickness shall withstand 180 degrees flatwise bending around a mandrel ten times the conductor thickness in both directions without exposure of the conductor.

Get In Touch

We would love to hear from you! Please fill out this form and we will get in touch with you shortly.
  • This field is for validation purposes and should be left unchanged.

“Copyright © 2016 DuPont. All rights reserved. The DuPont Oval Logo, DuPont™, The miracles of science™ and all products denoted with ® or ™ are trademarks or registered trademarks of E. I. du Pont de Nemours and Company or its affiliates”

DISCLAIMER: The technical information contained herein is the result of extensive testing in the manufacturer’s laboratories. In addition any application advice given verbally, in writing or by testing corresponds to the best of our knowledge and belief. Since the use and application of any of our products lies beyond our area of control, it remains the responsibility of the user to verify the product’s suitability for their application.

Back to Top